No. Task Notes
information, see File server configuration on
page 33.
In the IP Office environment, Avaya Vantage
™
requires an external HTTP or HTTPS file
server.
For more information about setting up the DHCP and file servers in the IP Office environment, see
Avaya IP Office
™
Platform SIP Telephone Installation Notes for Release 11.0.
DHCP server configuration
Configure the DHCP server to:
• Dynamically assign IP addresses to Avaya Vantage
™
devices.
• Provision device and site-specific configuration parameters through various DHCP options.
Setting up a DHCP server
About this task
Use this procedure to set up a third-party DHCP server. Avaya Vantage
™
supports any DHCP
server software as long as the software is correctly configured.
In the IP Office environment, you can use either the IP Office system as the DHCP server or a
third-party DHCP server. For more information, see Avaya IP Office
™
Platform SIP Telephone
Installation Notes.
Before you begin
Contact your server software vendor to obtain server software installation and configuration
instructions.
Procedure
1. Install the DHCP server software according to the server software vendor’s instructions.
2. Create a DHCP scope to define the range of IP addresses to use.
You can define different scopes from different types of devices.
3. Configure the required DHCP options.
The DHCP site-specific option that you configure must match the Site Specific Option
Number (SSON) that Avaya Vantage
™
uses. The default SSON that Avaya Vantage
™
uses
is 242 .
Server configuration
May 2018 Installing and Administering Avaya Vantage
™
32
Comments on this document? infodev@avaya.com
To Next Page
Loading...
