Avaya Vantage - Logging and Debugging Parameters

Logging and debugging parameters
Parameter Type Default
value
Is set to
default
on reset
Description
SYSLOG_ENABLE
D
Integer 0 Yes Specifies whether Avaya Vantage
™
generates
syslog messages. Assign one of the following
values:
• 0: Syslog messages are disabled.
• 1: Syslog messages are enabled.
This parameter is supported in all modes.
For provisioning, use:
• The SET command in the
46xxsettings.txtfile.
• The Settings menu on the device.
SYSLOG_LEVEL Integer 3 Yes Specifies the severity level of syslog messages.
Avaya Vantage
™
sends a syslog message if a
severity level of an event is equal or less than the
value specified in this parameter. Assign one of the
following values:
• 3: Error
• 4: Warning
• 5: Notice
• 6: Informational
• 7: Debug
This parameter is supported in all modes.
For provisioning, use:
• The SET command in the
46xxsettings.txtfile.
• The Settings menu on the device.
LOCAL_LOGS_EN
ABLED
Integer 1 Yes Specifies whether Avaya Vantage
™
stores log
messages. Assign one of the following values:
• 0: Local log storage is disabled.
• 1: Local log is storage is enabled.
This parameter is supported in all modes.
Table continues…
Supported configuration parameters
May 2018 Installing and Administering Avaya Vantage
™
134
Comments on this document? infodev@avaya.com