EasyManua.ls Logo

Avaya Vantage - Connecting Avaya Vantage to the Network

Avaya Vantage
172 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
• 802.3at PoE (Class 4)
• 48 Vdc power supply
If you use the 802.3at networking switch or the power adapter, Avaya Vantage
™
USB port delivers
up to 500mA. If you use the 802.3af networking switch, Avaya Vantage
™
USB port delivers up to
100mA.
You can use a 48 volt, 30 watt power adapter to power Avaya Vantage
™
in the following
conditions:
• You are using Wi-Fi to connect to the network instead of using an PoE networking switch
port.
• The networking switch port does not support the 802.3af or 802.3at PoE specification.
• The device requires more power than 802.3af and 802.3at PoE switch port is not available.
For example, when a USB device that requires more than 0.5 watt is connected to Avaya
Vantage
™
and only 802.3af PoE ports are available, Avaya Vantage
™
must be connected to a
power adapter.
You must purchase the power adapter separately.
If Avaya Vantage
™
is connected to both a 48 Vdc power supply and a PoE networking switch port,
then the following occurs if one of the power sources is disconnected:
• If the power adapter is disconnected, Avaya Vantage
™
reboots. If the networking switch
supports either the 802.3at or 802.3af specification, Avaya Vantage
™
continues to work after
the reboot.
• If the networking switch is disconnected, Avaya Vantage
™
continues to work without a reboot.
If Avaya Vantage
™
is connected to the PoE networking switch and the power adapter is
connected, Avaya Vantage
™
continues to work without a reboot.
Connecting Avaya Vantage
™
to the network
About this task
You can connect Avaya Vantage
™
to your network using a wireless or an Ethernet connection.
Procedure
1. (Optional) Connect a power adapter to the 48-V DC power connector at the back of Avaya
Vantage
™
and plug the power adapter into an electrical outlet if:
• Your network does not support the 802.3at (PoE) or 802.3af (PoE) injector specification.
• You want to use a Wi-Fi connection.
2. To use a wired Ethernet connection:
a. Plug one end of an Ethernet cable into the LAN connector at the back of Avaya
Vantage
™
.
Connecting Avaya Vantage
™
to the network
May 2018 Installing and Administering Avaya Vantage
™
29
Comments on this document? infodev@avaya.com

Table of Contents