Avaya Vantage - Page 93

Parameter Type Default
value
Is set to
default
on reset
Description
Important:
This parameter must only be used when using
a wireless headset if the base station is
connected to the headset connector of the
device. In other cases, such as when using a
wired headset, the value must be set to 0.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file.
• The Settings > Audio settings > Headset
signalling menu on the device.
This parameter is supported in all modes.
This parameter can be stored on the PPM or
backup server.
BAKLIGHTOFF Numeric 120 Yes Timer to disable the backlight on the phone display.
The range is from 0 to 999 minutes.
This parameter is supported in all modes.
For provisioning, use:
• The SET command in the
46xxsettings.txtfile.
• The Settings menu on the device.
This parameter can be stored on the PPM or
backup server.
CLICKS Numeric 1 No Specifies whether touch sounds are enabled.
• 0: Touch sounds are disabled.
• 1: Touch sounds are enabled.
This parameter is supported in all modes.
For provisioning, use the Settings > Sound &
notification > Other sounds > Touch sounds
menu on the device.
This parameter can be stored on the PPM or
backup server.
LARGEFONT Numeric 1 Yes Specifies the size of the font.
Assign one of the following values:
• 3: Huge font size.
Table continues…
Phone UI related settings
May 2018 Installing and Administering Avaya Vantage
™
93
Comments on this document? infodev@avaya.com