AxelTech OXYGEN 3000 PLUS - Digital Input; Analog Balanced Stereo Outputs; Dante I;O

82
TECH SPECS | SERVICE
OXYGEN
3000 PLUS
· User Manual · ENG
Digital Input
Connector
Balanced on 1 XLR
–
EMI Suppressed
Input Impedance 110 KΩ
Standard AES3
Audio Sample Rate 32/44.1/48/96/192 KHz with SRC
Resolution 24 bit
Dynamic Range (Converter Values) 124 dB
Analog Balanced Stereo Outputs
Connector
RJ45 Balanced
–
EMI Suppressed
Output Impedance
23
Ω, nominal 600 Ω
Nominal Output Level 0 dBu
Max Output Level (clipping point) +18 dBu
D/A conversion 24 bit / 48 Khz
Signal To Noise Ratio (referred to peak level) >110 dB
Stereo Separation (referred to peak level) >90 dB
THD+N <0,002 %
Dante I/O
Audio
Buffering
Up to 2000 samples per channel
Audio Flows In/Out
Up to 32x32 simultaneous streams
Audio Transport Formats Dante Audio over IP, AES67 RTP, SMPTE ST2110-30
RTP (enrolled devices)
Clock High quality, low jitter onboard SiLabs
Clocking Onboard word clock or external word clock
Control Interfaces SPI Master and Slave; GPIO; I2C
Digital Audio Formats TDM, I2S
Ethernet Standard RGMII/MII interface for Ethernet PHY or
switch chip
Form Factor
Card edge module. 4.5cm x 6cm (1.75” x
2.4”)
FPGA
High performance Xilinx Spartan6 FPGA
Microprocessor
Soft
-
core Microblaze processor
Network RGMII/MII