R5905754 /13 DPxK-32B 49
Tip: Write down the serial number of the xenon lamp. You will need this while updating the lamp
parameters after installation of the xenon lamp. The serial number of the xenon lamp is engraved in
the neck of the xenon lamp.
Image 4-22
8. Slide the anode connector in its position on the Lamp House as illustrated.
Caution: Avoid any tension on the anode wire, ensuring there is no mechanical stress on the lamp.
Image 4-23
9. Install the UV blocker assembly as illustrated. Use the opening at the side of the Lamp House to guide the
anode pin of the xenon lamp into the anode supporting mechanism of the UV blocker.
Image 4-24
Lamp & Lamp House
To Next Page
Loading...
