Barco DP2K-6E User Manual

R5906790 /04 Athena 27
In case the projector is equipped with an ICMP(-X), download the ICMP(-X) device certificate, request KDM
and DCP from your content supplier, ingest KDM and DCP, and play out the movie. for detailed instructions
see chapter “ICMP(-X)”, page 59, and user guide of the Communicator and/or (Web) Commander. Use the
Communicator (Touch Panel) to configure the applied source. See the user guide of the Communicator (Touch
Panel) for more detailed information.
In case the projector is equipped with a HD-SDI input module apply a single or dual channel SMPTE (HD-SDI)
source to the input ports of the HD-SDI input module and start up the projector. Use the Communicator (Touch
Panel) to configure the applied source. See the user guide of the Communicator (Touch Panel) for more
detailed information.
In case the projector is equipped with an Integrated Media Block (IMB) or Integrated Media Server (IMS) see
user guide of the IMB or IMS for detailed instructions.
Installation process

Barco DP2K-6E Specifications

General

Contrast ratio (typical)	1600:1
Projector native resolution	2K (2048x1080)
Ethernet LAN	Yes
Ethernet LAN (RJ-45) ports	3
Noise level	48 dB
AC input voltage	200 - 240 V