Instruction Manual w VERTICUS 5 Compressor Units
A-29
operator or customer service technician. This instruction
manual describes the settable parameters, but it cannot
go deeper into the specific settings for these diverse
applications and ambient conditions.
Nitrox Blending: this function is still in the
programming phase and will be realised in the near
future.
11.3.2. Safety
Warning of dangerous electrical voltage
Touching the equipment can result in
electrocution. Work on electrical systems
or operating equipment may only be car
ried out by an electrical technician or oth
er trained persons working under the su
pervision of an electrical technician and
must be performed in accordance with
electrotechnical regulations.
All covers must be kept closed during
operation.
Any data exchange or each installation of
software using a data carrier (e.g.
memory card, CD-ROM, USB Memory
Stick, etc.) or via networks such as the Internet
presents potential risks to the system. It is the sole
responsibility of the user to avoid these dangers and
to protect the system by the use of appropriate
measures, such as virus protection programmes,
firewalls etc., and by using only software from trusted
sources.
Do not make any changes to the programmes
(software).
The machine/installation should only be used in a
technically perfect condition and in an intended, safety
and danger aware method, taking into account the
operating instructions! In particular, faults that have a
negative effect on safety must be immediately rectified!
This equipment is intended exclusively for the control of
BAUER compressor installations. Any type of usage that
falls outside this scope is classified as improper usage.
Damage resulting from this is not the liability of the
manufacturer/supplier. The user alone bears the risk of
this. Intended use includes compliance with the
operating instructions.
All persons who handle electrical components and
equipment that is fitted in electrical components must
be earthed.
Measuring instruments and devices must be earthed.
Measuring tips on potential-free measuring instruments
must be briefly be earthed on suitable earthed surfaces
before being used to take measurements.
11.3.3. Operation
For detailed information concerning the control system
please refer to the circuit diagrams of the B-Control system
supplied with the unit.
Electrical circuit diagrams see control
system of the compressor installation.
In the displays in the following
description we have sample values from
one of many possible configurations. The
values actually displayed can therefore deviate from
those shown here.
To Next Page
Loading...
