Instruction Manual w VERTICUS 5 Compressor Units
ii
INTRODUCTION
NOTICE
Layout and use of instruction manuals
Working with pneumatic high pressure systems cannot always be considered safe and one should possess a
minimum knowledge of how to operate them. For this reason, please read this instruction manual before oper
ating your unit, to get to know the components and processes.
This instruction manual is made up according to the building block principle. It is divided into 7 sections, whose
content varies according to the type of unit, standard or special and of course the accustomized extras, which
are available for all our units in large numbers. With this kind of subdivision system, all sections should be in
existence, in order to give a complete picture. In other words: even if one particular component is not part of
the unit, the relative section will still be kept, although only a notice may be printed there. On the other hand,
other sections could be represented more than once if certain units require this. In such a case one only has
to refer to the applicable section, all superfluous ones can be removed. This is quite simple due to the ring
binding system.
Please note that the circuit diagrams in section F, unless otherwise stated, are the standard circuit diagrams
for your specific unit. So please always refer to the circuit diagram enclosed in the compressor unit control box,
in which any possible changes are registered.
The same thing applies for the spare parts lists in section G. To avoid misunderstanding when ordering spare
parts, we advise you to remove the parts that are not applicable. The spare parts lists that apply to the relative
unit are listed in the section Index.
To Next Page
Loading...
