BenQ T3300 - Connecting the System to a Bluetooth Device; Unpair a Bluetooth Device; DICOM Configuration; Adding Servers

To Next Page

To Previous Page

Using the System

T3300 Diagnostic Ultrasound System | 55 | B00601-010 4/10/17

NOTE

Consult your network administrator about the appropriate settings.

3. Touch to leave the settings. If the connection is successful, appears on the system

toolbar indicating the network strength.

5.10.3 Connecting the System to a Bluetooth Device

You can connect the system to another pointing or input device via Bluetooth.

NOTES

• Using features requiring a Bluetooth connection may consume more battery power.

• To extend battery life between charges, turn off Bluetooth when not using it.

• Maximum distance between two connected Bluetooth devices cannot exceed 5 meters.

1. Open the Quick Setup menu (See page 50).

2. Touch Bluetooth to go to Bluetooth settings.

3. The system scans for and displays the IDs of available Bluetooth devices within range.

4. Touch the ID of the Bluetooth device to pair with it.

5. Confirm the passkey that appears and touch Pair. On the other Bluetooth device, accept the

identical passkey for pairing.

6. Touch to leave the settings. Once your system pairs with the device, appears on the

system toolbar, and they stay paired until you unpair them.

5.10.4 Unpair a Bluetooth Device

Touch beside the connected device you want to unpair, and touch Unpair.

5.11 DICOM Configuration

The system conforms to the Digital Imaging and Communications in Medicine (DICOM) standard.

DICOM format is used for patient studies that are transferred among PACS, which make up a

hospital information management system, and for studies that are accessed by physicians at remote

viewing stations.

The DICOM networking option settings are usually obtained from a network administrator.

NOTE

Before DICOM configuration, ensure that the system is successfully connected to a wireless or

wired network.

To configure DICOM settings, touch > Settings > DICOM.

5.11.1 Adding Servers

1. Select a storage/worklist SCP (Service Class Provider) and touch Edit.

– Storage SCP: Used to take responsibility for and provide receipt of content sent by the

system.

– Worklist SCP: Contain scheduled patient procedure data and is used to import the data into

the patient information form.

2. Assign a name to the server and enter it in the Name field.