Field Description
• %: The country information of the access point is used.
Channel The number of channels you can select depends on the country
setting. Please consult the data sheet for your device.
Access Point Mode / Bridge Mode:
Configuring the network name (SSID) in Access Point mode
means that wireless networks can be logically separated from
each other, but they can still physically interfere with each other
if they are operating on the same or closely adjacent wireless
channels. So if you are operating two or more radio networks
close to each other, it is advisable to allocate the networks to
different channels. Each of these should be spaced at least four
channels apart, as a network also partially occupies the adja-
cent channels.
In the case of manual channel selection, please make sure first
that the clients actually support these channels.
Possible values:
• For Operation Band = @F /-
Possible values are to & and 3 (default value). 3 is
not possible in bridge mode.
• For Operation Band = @F
Possible values are &, , , and 3 (standard
value)
• For Operation Band = @F /- and @F
- and @F -
Only the 3 option is possible here.
Access Client mode:
In Access Client mode, you may only select the proper channel
in Client Mode = 3 @%.
Possible values:
• For Operation Band = @F /-
Possible values are to & and 3 (default value).
• For Operation Band = @F
10 Wireless LAN bintec elmeg GmbH
176 bintec RS Series
To Next Page
Loading...
