Field Description
Enter the time in milliseconds between the sending of two
beacons.
This value is transmitted in Beacon and Probe Response
Frames.
Possible values are to &.
The default value is ms.
DTIM Period Only for Operation Mode = 3%% or 3%% 61
with Client Mode 3 @%.
Enter the interval for the Delivery Traffic Indication Message
(DTIM).
The DTIM field is a data field in transmitted beacons that in-
forms clients about the window to the next broadcast or multic-
ast transmission. If clients operate in power save mode, they
come alive at the right time and receive the data.
Possible values are to .
The default value is .
RTS Threshold Here, you select how the RTS/CTS mechanism is to be
switched on/off.
If you choose . $, you can specify in the input field
the data packet length threshold in bytes (1 - 2346) as of which
the RTS/CTS mechanism is to be used. This makes sense if
several clients that are not in each other's wireless range are
run in one access point. The mechanism can also be switched
on/off independently of the data packet length by selecting the
value 317( or 317( $$(default value).
Short Guard Interval Enable this function to reduce the guard interval (= time
between transmission of two data symbols) from 800 ns to 400
ns.
Short Retry Limit Enter the maximum number of attempts to send a frame. This
value must be less than or equal to the value specified in RTS
Threshold. After this many failed attempts, the packet is dis-
carded.
bintec elmeg GmbH
10 Wireless LAN
bintec RS Series 181
To Next Page
Loading...
