Field Description
Possible values:
• 3(
• % +1(
• 5 %"1
• % <%
• A%
• %
• * ?%
• *+
• *+ +1(
The default value is 3(.
See RFC 792.
Connection State
Only if Protocol = *6
You can define a filter that takes the status of the TCP connec-
tions into account.
Possible values:
• 3( (default value): All TCP packets match the filter.
• "1: All TCP packets that would not open any new
TCP connection on routing over the gateway match the filter.
Destination IP Ad-
dress/Netmask
Enter the destination IP address and netmask of the data pack-
ets.
Possible values:
• 3( (default value)
• @: Enter the IP address of the host.
• )7:: Enter the network address and the related net-
mask.
Destination Port/Range
Only if Protocol = *6, .5
Enter a destination port number or a range of destination port
numbers that matches the filter.
bintec elmeg GmbH
11 Networking
bintec RS Series 243
To Next Page
Loading...
