Biolight Meditech S10 - Page 38

S10/S12/S10A/S12A Patient Monitor User’s Manual
3-11 

3.7.2.2. Exit the Standby Mode
To exit the standby mode, choose any of the following ways:
 Select 【 Resume Monitor 】 to exit the standby mode and resume monitoring the
current patient.
 Select【Discharge Patient】to discharge the current patient.
If the monitor automatically enters the standby mode after a patient is discharged,
choose any of the following ways to exit the standby mode:
 Select【Patient Management】 to exit the standby mode and admit a new
patient.
 Select【Monitor】to enter the patient information for preparing to admit a new
patient.
3.7.3. Demo Mode
In Demo mode, the monitor can demonstrate its major functions when patient or
patient simulator is not connected. The Demo mode is password protected
Choose the following way to enter the Demo Mode:
1. Select【Main Menu】from【System】column to select【Demo】.
2. Input the passwordselect【OK】.
Shut down and restart to exit the Demo Mode.
WARNING：
 The demonstration function is mainly used to display machine performance
and to train users. In the actual clinical use, it is forbidden to use the
demonstration function, so as to prevent the medical staff from mistakenly
thinking that the monitor displays the waveform and parameters of the
monitored patient, thus affecting the patient’s monitoring and delaying the
diagnosis and treatment.