Biolight Meditech S10 - Page 39

S10/S12/S10A/S12A Patient Monitor User’s Manual
3-12 

3.7.4. Night Mode
Night mode is a special clinical monitoring mode. Under the night mode, the alarm
volume, QRS volume and screen brightness turn to be lowest automatically. To avoid
disturbing the patient, night mode may be used.
3.7.4.1. Entering Night Mode
The steps of entering【Night Mode】as following:
1. Select【Night Mode】quick key or select【Main Menu】quick keyfrom
【Display】column to select【Night Mode】button.
2. In the pop-up menu, set thenight mode.
3. Select【Enter Night Mode】.
The night mode settings are as follows by default:
• Brightness: 1
• Alarm Volume: 2
• QRS Volume: 1
• Touch Tone: Off
• NIBP End Tone: Off
WARNING：
 Verify the settings of brightness, alarm volume, QRS volume and key tone
before entering the night mode. Pay attention to the potential risk if the setting
value is low.
3.7.4.2. Exit the Night Mode
To exit the night mode, follow this step:
1. Press【Exit Night Mode】quick key or select【Main Menu】quick keyfrom
【Display】column to select【Exit Night Mode】button.
2. In the pop-up box to select【OK】..
NOTE
：
The monitor resumes the previous settings after exiting the night mode.