Applying a LUT
Once you have a LUT saved onto your camera, tap it in the LUT menu to select it, and tap the
‘load’ icon. This will enable that LUT to all outputs on your camera. However, you will still have
to turn ‘display LUT’ on in the monitor menu for each output to apply it. See the ‘monitor
settings’ section in this manual for more information.
Exporting LUTs
To export a LUT to a CFast or SD card, select the LUT you want to export and tap the icon.
Youwill be prompted with two options, 'import LUT' and 'export selected LUT.' Use the storage
media selection switch on URSA Mini Pro 4.6K to select either SD or CFast, depending on the
location you would like to export the LUT to. If you are using URSA Mini SSD Recorder, you can
also export LUTs to an SSD.
Tapping ‘export selected LUT’ will prompt you to choose which card you want to export to.
Choosing a card will commence exporting, unless you are exporting a LUT that already exists
on that card. If a duplicate LUT is found, you will be asked if you want to overwrite the LUT on
your card, or if you would like to keep both.
Deleting LUTS
Your URSA Mini has space for six 17 point or 33 point 3D LUTs. To delete LUTs you are no longer
using, or make room for more, select the LUTs you want to delete and tap the icon. You will be
prompted to confirm your choice. Tap ‘delete’ to confirm.
NOTE If you are having trouble importing a LUT to your URSA Mini, it may be the wrong
size. You can use a LUT editor like Lattice to check its size, or open it in any text editor
on your computer. Next to the tag 'LUT_3D_SIZE' will be a number indicating the LUT's
size. If this value is not 17 or 33, you can use Lattice to resize your 3D LUT to 17 points.
125Settings
To Next Page
Loading...
