Peak
Press the ‘Peak’ button to activate focus peaking. Your camera has two focus peaking
modes, traditional focus peaking, which artificially sharpens areas of the image that are
in focus, and 'colored lines' with overlays the sharp areas of your image with black,
white, red, green or blue colored lines. See the 'monitor settings' section of this manual
for more information. Focus peaking is not recorded to storage media, but can be
displayed via the HD monitoring output and on the fold out monitor by activating
overlays using the touchscreen menu.
Program
The program button is marked PGM and lets you switch the LCD between the camera
view and any signal plugged into the camera's 12G-SDI input. This means if you’re using
URSA Mini Pro 4.6K in a live broadcast, you can plug in the switcher’s program output
and monitor it during the shoot. Press and hold the program button to see your
program feed. Double press the button to lock the program feed on. Press again to turn
the program feed off.
To display a switcher’s program output, your camera and switcher must be set to the
same resolution and frame rate.
Menu
Press the ‘menu’ button to open the dashboard. Refer to the ‘settings’ section for more
information about the dashboard feature and how to adjust settings.
Record
Press any of the record buttons marked REC to start and stop recording. Refer to the
‘recording’ section for more information.
Playback Control Buttons
The playback buttons let you start and stop playback, plus skip to the next or previous
clip. When using the EF mount, the forward and reverse skip buttons can also be used
to open or close the iris when using compatible lenses. Refer to the ‘playback’ section
for more information on how to use the playback buttons.
NOTE Some lenses have both manual and auto focus modes. In order for
URSA Mini to be able to auto focus with your lens, you need to ensure that your
lens is set to auto focus mode.
TIP If you are recording your video output to a Blackmagic Video Assist or
HyperDeck Studio Mini, you may want to ensure that you don’t have peaking
switched on for that output. This can be done by using our 'clean feed’ feature
on your front SDI or main SDI.
For more information on outputting a 'clean feed' see the 'monitor settings'
section in this manual.
68URSA Mini Pro 4.6K Control Buttons
To Next Page
Loading...
