Blackmagicdesign URSA Mini - Page 95

Display 3D LUT
Your URSA Mini can apply 3D LUTs to any output to approximate the look of color
graded footage. This is especially useful when shooting with ‘film’ dynamic range, as
these produce an intentionally ‘flat’ low contrast image.
If your URSA Mini has a 3D LUT active, use this setting to independently apply that
LUTto your LCD touchscreen, front or main SDI output.
Zebra
Tap the ‘zebra’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable zebra
guides for those outputs. For more information on zebra guides and setting zebra
levels, see the ‘touchscreen features’ section in this manual.
Focus Assist
Tap the ‘focus assist’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable
focus assist for those outputs. For more information on focus assist and setting focus
assist levels, see the ‘touchscreen features’ section in this manual.
Frame Guide
Tap the ‘frame guide’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable
frame guides for those outputs. For more information on frame guides and choosing
different guides, see the ‘touchscreen features’ section in this manual.
Grid
Tap the ‘grid’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable a rule of
thirds grid for those outputs. For more information on the rule of thirds grid, see the
‘touchscreen features’ section in this manual.
Safe Area Guide
Tap the ‘safe area’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable safe
area overlay for those outputs.
For more information on safe area guides, and setting the level of safe area guides,
seethe ‘touchscreen features’ section in this manual.
False Color
Tap the ‘false color’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable false
color exposure assistance for those outputs.
For more information on false color, see the ‘touchscreen features’ section in
this manual.
NOTE LUTs will still be applied to outputs with ‘clean feed’ enabled. To disable
LUTS, disable the ‘display LUT’ switch in the ‘Monitor’ menu for that output.
NOTE For more information on loading and using 3D LUTs, see the ‘LUTS’
section of this manual.
NOTE Use the 'safe area guide %' setting in your URSA Mini's 'all' monitoring
settings to set the size of the safe area guide.
97Settings