124 EM-ABS-01 for ACU 03/12
10.2 Compatibility list
The compatibility between Module Firmware and device Firmware is described in the following.
ACU
Firmware
EM-ABS-01 Firmware
1.0.1.0
EM-ABS-01 Firmware
2.0.1.0
5.0.x Invalid Combination Invalid Combination
5.1.x Invalid Combination Invalid Combination
5.2.0 Possible combination Invalid Combination
5.3.0 Invalid Combination Possible combination
The ACU Firmware can be read out via
Inverter Software Version 012 and the Module Firmware via
EM Software version 016.
10.2.1 Module Firmware 1.0.1.0
Note: An operation of modules with firmware 1.0.1.0 is only valid with devices
with firmware 5.2.0.
Devices with deviating device firmware may only be operated with EM-
ABS-01 modules firmware 1.0.1.0 after written confirmation through Bon-
figlioli.
10.2.2 Module-Firmware 2.0.1.0
Note: An operation of modules with firmware 2.0.1.0 is only valid with devices
with firmware 5.3.0.
Devices with deviating device firmware may only be operated with EM-
ABS-01 modules firmware 2.0.1.0 after written confirmation through Bon-
figlioli.
The Module Fi
rmware 1.0.1.0 requires basic device Firmware 5.2.0.
The following encoders are supported:
•
SinCos
•
Hiperface
•
EnDat 2.1 (with SinCos tracks)
Limitations:
•
In basic device firmware 5.2.0 several parameters of this operating instruc-
tions are not included.
The Module Firmware 2.0.1.0 requires basic device Firmware 5.3.0.
The following encoders are supported:
•
SinCos
•
Hiperface
•
EnDat 2.1 (with SinCos tracks)
•
SSI
To Next Page
Loading...
