Bosch DS7200V2-EXP - Page 78

DS7200V2-EXP | Installation Guide | 3. Control Panel
Programming
EN | 78
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
Duress Reporting Options
• Address: 0702
• Default: 0
• Selections: 0 to 15
Enter This Data Digit to Select Options
Duress Reporting Options
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
No User Emergency Function Reporting
•
Make User 32 a Duress User
•
•
•
•
•
•
•
•
Make User 31 a Duress User
•
•
•
•
•
•
•
•
Make User 30 a Duress User
•
•
•
•
•
•
•
•
Make User 29 a Duress User
•
•
•
•
•
•
•
•
This parameter creates up to 4 Duress users (and PINs). Creating a Duress user does not change any
other function programmed for that user.
Whenever a user enters a Duress PIN (PIN assigned to a Duress user), the control panel sends a
Duress {74} report and executes functions per the Duress user’s authority level.
DS7240V2 Procedure
To create a unique Duress user (and PIN) for each area, select Option 15 and then assign each of the
four users (User 29 through 32) to only one area.
To create one Duress user (and PIN) for all areas, select Option 1, 2, 4 or 8 and then assign that user
(User 29 through 32) to all four areas.
DS7220V2 Procedure
To create a unique Duress user (and PIN) for each area, select Option 3, 5, 6, 9, 10, or 12, and then
assign the two corresponding users (User 29 through 32) to only one area.
To create one Duress user (and PIN) for both areas, select Option 1, 2, 4, or 8, and then assign that
user (User 29 through 32) to both areas.
Guard Code Options
• Address: 0705
• Default: 0 (No Guard Code Options)
• Selections:
- 0 = No Guard Code Options
- 1 = User 28 is a Guard Code
User 28 can be programmed as a Guard Code. The Guard Code only works in the areas to which User
28 is assigned. The authority level assigned to the Guard Code (User 28) dictates which keypad
functions the guard can use.