152
5.13 Error Codes
5.13 Error Codes
Basic approach
X Print the diagnostic report
X Delete the error code
X If needed, perform a software update
X Restart the system
X If the problem persists, contact Bosch Service Hotline.
Classic+ Line
error code
in DiagnosticTool
error code
in display
Error description, repair
0x01 00 01 100
Internal error in the drive unit. Print the error report, delete the error code,
and restart the system. Carry out the test drive.
101
Communication problem between drive unit and other system components.
Check wiring and contacts.
0x01 00 12 105
Temperature in drive unit above permissible maximum value. Switch off the
system and wait at least an hour until the temperature has dropped to the
normal level.
0x01 00 14 104
Problem with the power supply of the on-board computer. Check connector
and wiring.
0x01 00 15
0x01 00 16
103
Problem with the power supply of the front or rear light (only when the
vehicle lighting is connected to the drive unit). Check the connection and
wiring of the front light (...15) or the rear light (...16).
0x01 00 17 102
Problem at the speed sensor. Check the sensor’s extension, wiring and
contacts.
0x42 20 10 422
Communication problem between drive unit and other system components.
Check wiring and contacts.
PerformanceLine CX, PerformanceLine,
ActiveLinePlus (BDU350), ActiveLine (BDU310), ActiveLine (BDU250C / 255C)
error code
in DiagnosticTool
error code
in display
Error description, repair
0x500128
0x500129
0x50012A
0x50012B
500 Internal drive unit software error, motor support is switched off.
0x500200
0x500201
0x500103
0x5B1104
0x500106
0x500107
500
Internal drive unit software error. Delayed motor support in the starting
phase.
0x501324
501 Internal temperature error, shutdown of the eBike system.
0x50212C
0x502108
0x502109
502
Internal error in light-voltage supply, motor support is switched off.
Check the front light as well as the wiring and the connection between
the drive unit and the front light. Restart the system.
To Next Page
