10
1.5 Power Supply and Technical Data
Technical Data Purion
Batteries 2x 3 V CR 2016
Operating temperature –5 ... 40°C
Storage temperature –10 ... 50°C
Type of protection IP 54 (protected from dust ingress/water spray)
Weight approx. 100 g
X Provided with power by two CR-2016 button cell
batteries
X If "LOW BAT" is shown on the display:
1. Loosen the fastening screw.
2. Remove Purion from the handlebar.
3. Use an appropriately-sized coin to open the
battery compartment cover.
4. Remove the used batteries.
5. Replace with new batteries.
6. Screw-close the battery compartment.
7. Reattach Purion on the handlebar (tightening
torque of fastening screw: 1 Nm).
If the batteries for Purion are discharged, then
the eBike can still be switched On at the eBike
battery. However, replace the batteries as soon
as possible to prevent any damage.
1.5 Power Supply
and Technical Data
To Next Page
