C
B
1A
187
6.6 Rack Battery 6.6 Rack Battery
Installing the PowerPack mount
1. Insert the PowerPack mount
into the rack. Make sure that
the centring pin (A) on the bike
rack engages in the cut-out on
the guide rail adapter (B).
2. Tighten the PowerPack mount
using two screws (C) on the
rear traverse of the bike rack
(screws not included in scope
of delivery).
Matching luggage rack can
be purchased from e.g.
Curana, Hebie, Pletscher,
Tubus-Racktime.
Stop in the PowerPack
mount, spare part Order
number:
1.270.014.018
X Tool dependent
on the screws used
X Torque wrench
X PowerPack mount on rack:
according to manufacturer's
instructions
Work steps Tool
Tightening
torques
6.6 Rack Battery
6
INSTALLATION/
REMOVAL
To Next Page