Callout ￚ Description
1 ￚ Jumper installed in this position activates the Low setting.
2 ￚ Jumper installed in this position activates the High setting.
3 ￚ No jumper installed disables the Minor Attack setting.
Major Attack setting
A single, strong vibration detected by the sensor causes a major attack. Select one out of
three sensitivity options from the list below:
– Medium
– High
– Low
Callout ￚ Description
1 ￚ Jumper installed in this position activates the Medium setting.
2 ￚ Jumper installed in this position activates the High setting.
3 ￚ No jumper installed activates the Low setting.
Reed switch setting
You can set the detector to enable or disable the reed switch, depending on the positioning of
the jumper. Use the following procedure for the desired outcome.
Callout ￚ Description
1 ￚ Jumper installed in this position enables the reed switch.
2 ￚ Jumper installed in this position disables the reed switch.
Easy Series Control Panel Device Specifications and Overview | en 101
Bosch Security Systems, Inc. System Reference Guide 2014.09 | 01 | F.01U.306.221
To Next Page
Loading...
