Bosch ICP-EZM2 - Page 56

Programming Item Item
Number
Manuf.
Default
Programming Item Item
Numbe
r
Manuf.
Default
Close Remote 340 3 3
*Enter a value to globally set all of the following reports to the same value.
To modify only a specific report, enter a value in that report's item number.
0 = Neither route
1 = Route 1 only; Primary and Backup
2 = Route 2 only; Primary and Backup
3 = Both routes; Primary and Backup
System Report and Restoral Routing
Programming Item Item
Numbe
r
Manuf.
Default
Programming Item Item
Numbe
r
Manuf.
Default
System Reports and Restorals (all)
1
303 3 Communication Restoral 352 3
User Emergency
2
319 3 Control Center Supervision Fail 353 3
User Fire
3
320 3 Control Center Supervision Restoral 354 3
User Fire Restoral 321 3 Control Center Tamper 355 3
User Panic 322 3 Control Center Tamper Restoral 356 3
AC Fail 345 3 System Inactive 385 3
AC Fail Restoral 346 3 Watchdog Reset 390 3
Auto System Test Normal 347 3 Passcode Tamper 391 3
Auto System Test Off-Normal 348 3 Date/Time Changed 410 3
Auxiliary Power Fault 349 3 Network Fail 413 3
Auxiliary Power Restoral 350 3 Network Restoral 414 3
Communication Fail 351 3 3
Local Programming Success* 357 3 Bus Device Trouble 373 3
Low Battery 358 3 Bus Device Trouble Restoral 374 3
Low Battery Restoral 359 3 ROM Fault 375 3
Communication Test, Manual 362 3 Bell Trouble 376 3
Phone Line Fault 363 3 Bell Restoral 377 3
Phone Line Fault Restoral 364 3 Walk Test End 378 3
Remote Programming Failure 365 3 Walk Test Start 379 3
Remote Programming Success 366 3 Bus Device Missing 380 3
Wireless Receiver Jammed 367 3 Bus Device Missing Restoral 381 3
Wireless Receiver Jammed Restoral 368 3 Battery Missing 382 3
Bus Device Tamper 369 3 Battery Missing Restoral 383 3
56 en | Programming Easy Series Control Panel
2014.09 | 01 | F.01U.306.221 System Reference Guide Bosch Security Systems, Inc.