Brady M610 - Error Messages and Diagnosis

M610 Label Printer User Manual 9
Setup
Printer Settings
Date and Time
Set the printer’s clock to the current date and time. Also set the format to use when adding the current
date or time to a label.
To set the date and time:
1. Press FN + SETUP.
2. Use the navigation keys to move through the menu until Time/Date is highlighted.
3. Press ENTER to accept the choice and display the time and date settings.
4. For information on how to use the screen, see “Settings Screens” on page 22. Most of the
settings on this screen are self-explanatory, but the following information may be useful.
• Display 24 Hour: Hours are numbered 1-24. Clear this field to use hours 1-12 and AM/PM.
• PM: Not available if Display 24 Hour is selected. Clear this check box for AM; set it for PM.
5. Navigate to OK and press ENTER.
6. Press ENTER to dismiss the menu.
Pause/Cut
The Pause/Cut function allows you to pause or not pause printing after each label to cut the label.
To turn on/off Pause/Cut:
1. Press FN + SETUP.
2. Use the navigation keys to move through the menu until Pause/Cut is highlighted.
3. Use the up and down navigation keys to select On or Off.
4. Press ENTER to accept the choice.
Printer Configuration
Use the Config menu to set the brightness, automatic shutdown, and to clean the printer.
To configure the printer:
1. Press FN + SETUP.
2. Use the navigation keys to move through the menu until Config is highlighted.
3. Press ENTER to accept the choice and display the printer configuration settings.
4. For information on how to use the screen, see “Settings Screens” on page 22.
• Brightness: Change the brightness of the screen.
• Shut Off Delay: Set the amount of time, in minutes, that the printer should remain idle
before powering off automatically.
• No Shut Off (AC): Select this check box to turn off the automatic shutdown, which is not
needed when the printer is plugged in.
• Clean Printer: For more information see “Cleaning the Printer” on page 74.
• About: Displays the installed Firmware and Label Library versions as well as the Bluetooth
module.
5. Navigate to OK and press ENTER.
6. Press ENTER to dismiss the menu or use the navigation keys to go to the next setting to configure.