Brady M610 - Default Formatting; Default Settings; Formatting Text; Typeface

M610 Label Printer User Manual 33
Editing Labels on the Printer
Default Formatting
2. Select the desired option or cancel the deletion by pressing the Backspace key.
3. If you selected Clear All, a confirmation message displays. Navigate to Yes in the message
and press ENTER.
Default Formatting
Default Settings
Default settings are determined by the printer for the installed label supply. When the label supply or
application label type is reloaded, it will return to these settings. The font and its attributes can also be
set as a default using Font Settings.
Formatting Text
Character and line formats called attributes change the appearance of the fonts, such as size, weight
(bold), angle (italics), underline, and expanding or condensing the text. Different formatting features
can be found under the Font, Label, and Area functions..
Typeface
The typeface (font style) is determined in the setup menu and cannot be changed on individual labels
or lines. See “Font” on page 10. Fonts cannot be downloaded to the printer.
Font Size
Font size applies to an entire line of data at a time and is measured in point size or millimeters, as
determined in the Setup function.
If the size is changed before the data is entered, all the data in the current and subsequent lines takes
on the new font size until font size is changed again. Changing the font size on pre-entered data
changes the size on the entire line, regardless of where the cursor is in the line. However, the font size
will not change on subsequent lines of pre-entered data. You must change the font size on each
individual line of pre-entered data.
To change the size of the chosen font:
1. Position the cursor on the line of text that you want to resize. See “Positioning the Cursor” on
page 32.
2. Press FONT.
A pop-up menu displays the available font sizes for the label supply installed.
3. Navigate through the Size menu to select the desired font size.
• Custom: To manually enter a size, select Custom . The minimum/maximum range is shown
below the type-in field. If you exceed these values an error will display.