M610 Label Printer User Manual 75
Maintenance
Cleaning the Printer
Replacing the Cutter Cover
If the printer is accidentally dropped, the cutter cover may come loose or fall out. If the cover is not
dented or damaged, re-insert it into the printer.
1. Grasp the cover from the top with the cut-out portion facing the display screen (away from the
label supply well).
2. Pull the black flap forward, then insert tight up against the black flap with the metal tabs fitting
over the outside of the cutter housing.
3. Press into place.
Side of cutter housing
Side of cutter housing
Back flap
Cutter cover
Metal tabs
To Next Page
Loading...
