Disassembly / Assembly SpaceCover
5
SpaceStation, 1.0 gb 5- 11
1.0
5.9 Assembly / Installation
Assembly or installation of the modules and subsystems is done in
reverse order of disassembly. Special steps to be observed are de-
scribed hereafter in detail.
Only new cover caps are to be used.
Special Screws
Special screws for plastic housings are used in this unit. The
screws are not self-cutting but produce a thread in the plastic of
the housing through deformation when fitted in for the first time.
If the beginning of the thread is not engaged when the screw is
fitted, a new thread is produced and the old thread is destroyed
so that the security of the fixing can no longer be guaranteed.
Proceed as follows to fit the special screws:
1. Put the screw on the thread.
2. Rotate screw anti-clockwise (loosen) until a faint click can be
heard. This click is produced when the screw thread drops
into the existing thread.
3. Screw in the screw and tighten with the defined torque.
To Next Page
Loading...
