X7-8-Install-IG100 Installation Guide
Brocade
®
X7-8 Director Hardware Installation Guide
GE: Slot 9/Port 17: --
slotShow
Use the slotShow command to display the current status of each blade in the system. Depending on the option used, the
command retrieves information on blade type, blade ID, status, Brocade model name, and power usage for each slot in
the switch or chassis. Use the -m operand to display the blade model name and status.
Following is an example of slotShow output.
NOTE
The most common status is shown. A status of Faulty (51) would display for a POST failure during power-on or
a blade hot-plug.
Gen7-8:admin> slotShow -m
Slot Blade Type ID Model Name Status
--------------------------------------------------
1 CP BLADE 175 CPX6 ENABLED
2 CP BLADE 175 CPX6 ENABLED
3 SW BLADE 178 FC32-48 ENABLED
4 SW BLADE 178 FC32-48 ENABLED
5 AP BLADE 186 SX6 ENABLED
6 SW BLADE 178 FC32-48 DISABLED
7 CORE BLADE 176 CR32-8 ENABLED
8 CORE BLADE 176 CR32-8 ENABLED
9 SW BLADE 178 FC32-48 ENABLED
10 UNKNOWN VACANT
11 SW BLADE 178 FC32-48 ENABLED
12 SW BLADE 178 FC32-48 ENABLED
switch:admin>
supportSave
Use the supportSave command to collect RASLOG, TRACE, supportShow, core file, FFDC data, and other support
information to a remote FTP location. On platforms that support a USB, the information can also be stored on an attached
USB device. SupportShow information is available on active and standby CPs.
The following is an example of supportSave output. This output assumes that the supportFtp command was used to
set up FTP parameters (always recommended). In the following examples, the -c operand allows use of the FTP, SCP, or
SFTP parameters set by supportFtp . The -n operand turns off confirmation prompting.
Gen7-4:admin> supportftp
Host IP Addr: 10.154.6.41
User name: ak4089752
Remote Dir: /tftpboot/dumps/supportsave/test01/x7-4
Auto Upload protocol: sftp
SCP/SFTP port: 22
Auto-FTP: On
Gen7-4:FID128:root> supportsave -n -c
Saving support information:
X7-8-Install-IG100
102
To Next Page
Loading...