X7-8-Install-IG100 Installation Guide
Brocade
®
X7-8 Director Hardware Installation Guide
Port blades contain the following LED indicators. For details on interpreting LED operation, see Supported Transceivers
and Cables.
•
Green blade power LED
•
Amber blade status LED
•
Bicolor green/amber port status LEDs
Flexport allows you to configure individual ports on the FC32-64 blade for Fibre Channel (FC) or Fibre Channel over
Ethernet (FCoE) connections when qualified FC or Ethernet transceivers are installed in the ports. Configure FC (default)
or Ethernet operation for a port using the portcfgflexport command.
•
FC operation allows the connection of blades to fabric storage, servers, and switches. An FC transceiver must be
installed in a port to configure FC operation for that port. Supported FC transceivers include 4x32Gb/s QSFP28 and
4x16Gb/s QSFP+ transceivers.
•
FCoE operation allows the connection of blades to FCoE devices as part of a unified fabric. The FCoE devices can be
servers or connections through an FCoE Initialization Protocol snooping bridge (FSB). An Ethernet transceiver must be
installed in a port to configure FCoE operation for that port. Supported Ethernet transceivers include 40GbE, 4x10GbE,
and 4x25GbE QSFP+ transceivers.
Reference the following resources for more information:
•
For a complete list of qualified transceivers for this blade, see Supported Transceivers and Cables.
•
For more details on FCoE, Flexport, and breakout mode features and commands, refer to the Brocade Fabric OS
Administration Guide and Brocade Fabric OS Command Reference Manual.
FC32-64 Port Blade Numbering and Trunking
The following illustration shows how ports are numbered on the blade.
X7-8-Install-IG100
114
To Next Page
Loading...
Need help?
General
