Broadcom Brocade X7-8 - Interpreting Core Routing Blade Leds

X7-8-Install-IG100 Installation Guide Brocade
®
X7-8 Director Hardware Installation Guide
Table 18: LED Descriptions for 10/100/1000Mb/s Ethernet Ports: CPX6+ (Upgraded Chassis)
LED Inactive link 10Mb/s 100Mb/s 1000Mb/s
Ethernet link status
(10/100/1000Mb/s port)
No light (LED is off) Blinking green Blinking green No light (LED is
off)
Ethernet link activity
(10/100/1000Mb/s port)
No light (LED is off) No light (LED is off) Blinking green Blinking green
NOTE
If an link is inactive, ensure that the blade has power, the Ethernet cable is firmly seated, and the connected
device is functioning.
Interpreting Core Routing Blade LEDs
See the following figure and table to interpret the LED patterns on the CR64-4 blade. The LED patterns temporarily
change during POST and other diagnostic tests.
X7-8-Install-IG100
83
Broadcom