Broadcom Brocade X7-8 - Installing the Device in the Rack

X7-8-Install-IG100 Installation Guide Brocade
®
X7-8 Director Hardware Installation Guide
device to the rack rails using 10-32 x 5/8 inch screws. Use three clips on each rail. Place the clips in optimum locations
for securing the device to the rails.
NOTE
Do not align the clip or retainer nuts with the top or bottom holes of the mounting bracket because the screw
heads will interfere with the door.
Installing the Device in the Rack
Use the following procedure to install the device in the rack.
X7-8-Install-IG100
32
Broadcom