Broadcom Brocade X7-8 - Time and Items Required; Removing a Fan Assembly

X7-8-Install-IG100 Installation Guide Brocade
®
X7-8 Director Hardware Installation Guide
6. Verify that the fan assembly status LEDs are green.
Time and Items Required
The replacement procedure for each fan assembly takes less than 5 minutes. The following items are required for the
blower assembly replacement:
•
Replacement fan assembly
•
No. 1 Phillips screwdriver
Removing a Fan Assembly
Complete the following steps to remove a fan assembly from the chassis.
1. Before removing a fan assembly, refer to Precautions Specific to Fan Assemblies to verify whether you can remove
the power supply and leave the chassis operating (hot-swap replacement).
2. Perform one of the following steps:
•
If you need to power down the chassis to remove a fan assembly, enter the sysShutdown command. When
command output indicates the chassis has completed shut-down, remove power cords from all power supply
assemblies.
•
If you can hot-swap the fan assembly, go on to the next step.
NOTE
Replace fan as soon as possible to avoid overheating and eventual system shutdown.
X7-8-Install-IG100
176
Broadcom