Broadcom Brocade X7-8 - Interpreting FC32-64 Port Blade Leds

X7-8-Install-IG100 Installation Guide Brocade
®
X7-8 Director Hardware Installation Guide
LED Purpose Color Status Recommended Action
Slow-flashing amber (on 2
seconds, then off 2 seconds)
The port is disabled
due to diagnostic tests
or portDisable or
portCfgPersistentEnable
command.
Reset the port from
the workstation using
the portEnable or
portCfgPersistent
Enable command.
Fast-flashing amber (on 1/2
second, then off 1/2 second)
The
transceiver or port is faulty.
Change the transceiver or reset
the switch from the workstation.
Alternating green/amber The port is beaconing. No action is required.
Interpreting FC32-64 Port Blade LEDs
See the following figure and table to interpret the LED patterns for the FC32-64 blade. The LED patterns temporarily
change during POST and other diagnostic tests.
X7-8-Install-IG100
76
Broadcom