Programmer
32
Chapter 2 Programming with Help Function
3. Move the needle with . Press
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
4. Program the outer pattern.
5. Press
ESCESC
after input of point B.
The number of pressing
ESCESC
depends on the programming
method for outer pattern.
When
is used for programming, press twice.
When each stitch is programmed, press once.
6. Select with , then press .
7. Move the needle with
. Press
when the needle point is at point C of the
pattern.
8. Press
ESCESC
.
9. Program the inner pattern.
10. When point D is programmed, press
ESCESC
.
The number of pressing
ESCESC
depends on the programming
method for inner pattern.
When is used for programming, press twice.
When each stitch is programmed, press once.
Inputting the end code
1. Select with , then press .
2. Press
.
Press and the needle returns to the first stitch(point A).
To Next Page
Loading...
