Brother BAS-761 - Page 91

Programmer
90
Chapter 3 Programming with Command Function
3. Program the outer pattern.
4. Input point B, then press
F
.
5. Move the needle with
. Press
L
when the needle point is at point C of the
pattern.
6. Program the inner pattern.
2
Inputting the end code
1. Press
E
1
1 1
.
The needle returns to the sewing start position.
3
Saving
1. Specify the program number on the
operation panel, then press
switch for
writing into the floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.
4
Ending program
1. Press
P
.