Programmer
94
Chapter 3 Programming with Command Function
1. Move the needle with . Press
L
when the needle point is at 5'.
5' is programmed.
2. Repeat step 1 and program 6' and 7'.
3. Press
1
, then press .
The needle point moves to 5.
Deleting unnecessary points
1. Press
C
.
2. Input the number of stitches to be deleted, then
press
.
The example is deleting 3 stitches ahead. Press
3
.
3. The needle point moves to 6, 7 and 8. Points 5,
6 and 7 are deleted.
Saving
1. Specify the program number on the operation
panel, then press
switch for writing into the
floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.
Ending program
1. Press
P
.
To Next Page
Loading...
