Brother DCP-L5652DN Service Manual

5-9
Confidential
<Operating Procedure>
(1) Press the [1], and then the [0] key in the initial state of maintenance mode. "WSW00" is
displayed on the LCD.
(2) Enter the worker switch number that you want to change the setting.
The following display appears on the LCD.
(3) Press the [ ] or [ ] key to move the cursor to the desired selector, and change the
setting by pressing the [1] or [0] key.
(4) When changing the setting is completed, press the [SET] key. The new selector setting
value is stored in the EEPROM, and the LCD returns to the ready state for worker switch
number entry ("WSW00").
(5) When all switch setting is completed, press the [X] key to return the machine to the initial
state of maintenance mode.
Note:
• To cancel operation and return to the initial state of maintenance mode, press the [X] key.
• If there is no entry for one minute or longer on 2-digit worker switch number selection after
the first digit was entered, the machine returns to the initial state of maintenance mode
automatically.
WSWXX = 0 0 0 0 0 0 0 0
Selector No. 1 Selector No. 8

Brother DCP-L5652DN Specifications

General

Printer Type	Laser
Functions	Print, Copy, Scan
Automatic Duplex Printing	Yes
ADF Capacity	50 sheets
Memory	256 MB
Processor	800 MHz
Monthly Duty Cycle	Up to 50, 000 pages
Print Speed	42 ppm
Print Resolution	1200 x 1200 dpi
Paper Input Capacity	250 sheets
Scanner Resolution	Up to 1200 x 1200 dpi
Connectivity	USB, Ethernet
Mobile Printing	Brother iPrint&Scan, Google Cloud Print, AirPrint, Mopria
Toner Yield	Standard: 3, 000 pages, High Yield: 8, 000 pages