5-26
Confidential
Adjust upper-end print position
<Function>
In the event that the upper-end print start position deviates, use this function to adjust the
position up and down. Adjustable range is -50 to 50 (unit: 300 dpi). (Shifted down when the
value is negative)
<Operating Procedure>
(1) Press the [4], and then the [5] key in the initial state of maintenance mode. "USBNo." is
displayed on the LCD.
(2) Press the [▲] or [▼] key to display
"Y Adjust" on the LCD, and press the [Mono Start] or [SET] key. "YAdjust MP" is
displayed on the LCD.
(3) Refer to
<Adjustment option table>
on the last page, press the [▲] or [▼] key to select
from the adjustment options, and press the [Mono Start] or [SET] key. "YAdj. **= 0*" is
displayed on the LCD. (Selected option is shown for **.)
(4) To shift the writing start position down, press the [▼] key to decrease the value. To shift
the position up, press the [▲] key to increase the value.
(5) Press the [Mono Start] or [SET] key after adjusting the value. "Accepted" is displayed on
the LCD.
(6) Press the [X] key to return the machine to the initial state of maintenance mode.
Set HEXDUMP Mode
<Function>
This function is used to enter HEXDUMP Mode (hexadecimal mode) or not when the
machine starts next time.
Note:
• Do not turn this ON, otherwise the machine enters HEXDUMP mode when it starts. If it
is ON and the machine starts in HEXDUMP mode, you can return the machine to the
ready state by turning the power OFF then ON again.
To Next Page
Loading...
Need help?
General
