Brother HL-2400C - Page 159

V-38
48 EACH IMAGE SET
This mode can reset the number of total pages of each color in the NVRAM whenever
NVRAM INITIAL is executed or the MCTL PCB is replaced.
Note: Do not perform this mode other than when replacing the MCTL PCB.
Description of Procedures LCD Message
1) Press the Continue button after selecting
Screen (a) “EACH IMAGE SET”.
(a)
→
(b)
2) Select the desired color to reset in EACH
IMAGE SET. (b)
→
(c)
3) Use the Set or
▼
button to select the desired
digit.
Use the Continue button to input values to
the selected (blinking) digit.
Upon completing the input of the values, use
the Set or
▼
button to select SET on the LCD
and then press the select button to store the
set value. (c)
→
(d)
4) Press the Font button to exit the EACH
IMAGE SET mode.
39 FACTORY MODE
EACH IMAGE SET
48 IMAGE OF
a)
b)
c)
Y/M/C/K
39 FACTORY MODE
DP CHECK
48 IMAGE OF C
005432 P SET
48 IMAGE OF
Y/M/C/K
d)
e)