VII-35
9) Remove the set screws BT3X8 (4 pcs.) from the paper exit guide unit.
10)Remove the top cover (paper exit cover) from the paper exit guide unit.
Fig.7-58
Note:
• When re-assembling, ensure the hooks are fitted facing in the correct direction on the
release arm. The two hook assembly sliders are of different widths to ensure correct
assembly. (Refer to Fig.7-59 below.)
Fig.7-59
• When refitting the paper exit inner cover, fit it onto the top cover while holding the
release arm in position with a screw driver for easier and correct assembly.
Spring
Hook(L)
Hook(R)
Paper exit
guide unit
Top Cover
(Paper Exit Cover)
To Next Page
Loading...
