A-13
5) Remove the oil remaining in the fusing
unit with the supplied syringe to avoid
oil spill in the printer.
Note:
Re-install the fusing unit into the printer
after cleaning the printer as instructed in
the following section. For re-install of the
fusing unit, see Section 6.6 ‘Packing’.
6.4 Waste Toner Pack
1) Remove the waste toner pack from the
printer.
2) Clean toner around the pack and cover
the hole of the waste toner pack firmly
with gummed paper tape.
3) Put the waste toner pack into the
polyethylene bag and seal it firmly.
6.5 Cleaning
Clean the following areas with a vacuum cleaner to remove toner.
1) Around the waste toner pack / Waste
toner feeder tube.
i) Remove the one screw of side
cover (R) at the rear of the printer to
remove the side cover (R).
ii) Vacuum toner from the exit of the
waste toner feeder tube and around
the waste toner pack holder.
iii) Cover the exit of the waste toner
feeder tube with vinyl wrap.
Waste
Toner Pack
Gummed
paper tape
To Next Page
Loading...
