A-12
5) Put the OPC belt cartridge into the
original starter kit packing.
CAUTION
• Do not directly touch the OPC belt surface with bare hands or gloves.
• If the belt is exposed for more than two minutes to a light source of 800 lux, the belt
may be damage.
• If you do not have the original starter kit packing, pack the OPC belt cartridge firmly
with bubble sheet and put it into the outer carton.
6.3 Fusing Unit
1) Open the rear access cover and
slacken the fusing unit securing screws
(2 pcs.)
2) Holding the handles at both ends of the
fusing unit and remove the fusing unit
from the printer.
3) Remove the oil bottle and the fuser
cleaner from the fusing unit and put
each of them into the polyethylene
bag.
CAUTION
Pack the oil bottle in the polyethylene bag
and seal it firmly. Failure to do so will
cause oil spill during shipping and damage
to the printer.
4) Put the oil bottle and the fuser cleaner
into the original starter kit packing.
Starter Kit
Packing
OPC Belt
Cartridge
Starter Kit
Packing
Fuser Cleaner
Fusin
Unit
Oil Bottle
Fuser Cleaner
Oil Bottle
To Next Page
Loading...
