Confidential
v
9.43 Paper Feed Roller ............................................................................................. 3-100
9.44 Paper Ejection Roller......................................................................................... 3-101
9.45 Platen ................................................................................................................3-103
9.46 Maintenance Unit/Ink Absorber Felt (for Maintenance Unit)..............................3-104
9.47 Inner Chute ASSY .............................................................................................3-105
9.48 Registration Sensor PCB ASSY........................................................................ 3-107
9.49 T1 Base Pad...................................................................................................... 3-108
9.50 T2 Base Pad...................................................................................................... 3-109
9.51 T1 Paper Pull-in Roller ...................................................................................... 3-110
CHAPTER 4 ADJUSTMENTS AND UPDATING OF SETTINGS, REQUIRED AFTER
PARTS REPLACEMENT............................................................................... 4-1
1 IF YOU REPLACE THE MAIN PCB............................................................................... 4-1
1.1 Customize destinations (Maintenance mode 74) .................................................. 4-3
1.2 Set the CIS type (Maintenance mode 59) ............................................................. 4-3
1.3 Install the firmware (Maintenance mode 28) ......................................................... 4-3
1.4 Initialize the EEPROM parameters (Maintenance mode 01)................................. 4-5
1.5 Restore the head calibration data (Maintenance mode 68)...................................4-5
1.6 Set the serial number (Maintenance mode 80) ..................................................... 4-5
1.7 Updating of head property data and backup/restoration of head calibration data
(Maintenance mode 68).........................................................................................4-6
1.8 Restore machine information (Maintenance mode 46).......................................... 4-6
1.9 Adjust the touch panel (Maintenance mode 78) .................................................... 4-6
1.10 Acquire white/black level data (Maintenance mode 55) ........................................ 4-7
1.11 Adjustment of software correction for inclination/corrugation/ruled lines
(Maintenance mode 65).........................................................................................4-7
1.12 Updating of paper feeding correction values (Maintenance mode 58) .................. 4-7
1.13 Adjustment of margins in borderless printing (Maintenance mode 66) ................. 4-7
1.14 Reset purge and flushing counts........................................................................... 4-7
1.15 Write head calibration data (Maintenance mode 02)............................................. 4-7
1.16 Check scanning and printing ................................................................................. 4-8
2 IF YOU REPLACE THE HEAD/CARRIAGE UNIT......................................................... 4-9
2.1 Update the head property data (Maintenance mode 68)..................................... 4-10
2.2 Perform ink supply purge (Maintenance mode 76).............................................. 4-11
2.3 Check head nozzles (Maintenance mode 09) ..................................................... 4-11
2.4 Adjust head inclination.........................................................................................4-11
2.5 Adjustment of software correction for inclination/corrugation/ruled lines
(Maintenance mode 65).......................................................................................4-13
2.6 Updating of paper feeding correction values (Maintenance mode 58) ................ 4-13
To Next Page
Loading...
Need help?
General
