3-93
Confidential
9.40 Flushing Box
(1) Release the two Hooks, lift up the front end of the Flushing box, and remove the
Flushing box.
Fig. 3-103
Assembling Note: If you replace the Flushing box (without replacing the Main PCB
ASSY), reset the flushing count, using the procedure given in Chapter 4, Section 1.14
"Reset purge and flushing counts".
It is also recommended that the Ink absorber box be replaced and the purge count be
reset as necessary since the purge count may approach the upper limit.
To Next Page
Loading...
