Brother MFC-J2320

Confidential
2-14
3.2 Error Messages
Error Message State
Error
Code
Reference
B&W 1-sided Print
Only
Replace Ink
After judging getting close to ink replacing
timing by the ink remaining sensor, ink
discharged for specified times.
Printing is possible for black only
documents.
26,27,28,29
Cannot Detect
Cannot identify a ink cartridge.
20,21,22,
23,24,25
Cannot detect ink
volume
Ink remaining counter in the ink cartridge IC
chip becomes 0.
26,27,28,29
Cannot Print
Replace Ink
Ink ejection has reached the specified
number of times when the ink remaining
sensor detects that the ink replacement
period is approaching.
26,27,28,29
Comm. error
Communications error occurs. 4.9.3
Cover is Open.
Detect document scanner open state. A1
Detect ink cartridge cover open state. 2F
Document Jam
Document scanning position sensor detects
paper jam inside ADF.
A2,A3
High Temperature
Machine interior thermistor detects that
room temperature is too high.
40
Ink Absorber Full
Purge count or flushing count reach upper
threshold.
46
Ink Absorber Near
Full
Purge count or flushing count are near
upper threshold.
4.10.7
Ink low
Ink remaining sensor detects near ink
replacing timing.
4.10.6
Install Starter Ink
The ink cartridge which does not contain
required ink volume for the initial installation
has been set at the initial installation.
24
4.10.6
Low Temperature
Machine interior thermistor detects that
room temperature is too low.
40
Media Error
Detect defective in memory card. 4.10.2,
4.10.3
No Ink Cartridge
Ink cartridge detection sensor detects no
cartridge.
2A,2B,2C,
2D