To Next Page

To Previous Page

3-111

Confidential

9.41 Ink Refill ASSY

(1) Remove the Ink supply tube from the Support wire.

(2) Remove the Ink supply tube from the Tube support plate.

(3) Release the wiring of Carriage motor harness attached to the Ink refill ASSY.

(4) < Ink tank model / Simple Ink cartridge model only >

Peel off the Cable band just from the Ink sensor flat cable.

Note: Do not remove the Cable band from the Lower cover to reuse it when mounting

a new Ink refill ASSY.

(5) Release the wiring of the Ink sensor flat cable from the Lower cover.

(6) < Ink tank model only >

Remove the two screws (TAPTITE CUP B M3x10) from the Ink refill ASSY.

(7) Remove the Ink refill ASSY from the Lower cover.

< Ink cartridge model >

Fig. 3-136

< Ink tank model >

Fig. 3-137

Routing of harnesses: See “ Main PCB/Modem PCB”.

Ink supply tube

Support wire

Tube support plate

Hooks

Ink refill ASSY

Cable band

Ink sensor flat cable

Lower cover

(Simple Ink cartridge model only)