3-119
Confidential
(6) Remove the Guard film from the Guard film spring.
(7) Remove the Guard film from the CR frame ASSY.
Note: When performing this procedure, place the unit in a way that the section “A” of
the Carriage motor harness will not be damaged.
Fig. 3-150
(8) Remove the screw (TAPTITE CUP S M3x6) from the CR frame ASSY.
Assembling Note:
Tighten the screw (TAPTITE CUP S M3x6) temporarily and then
perform the following procedures before mounting the Upper cover.
1) Mount the Head/carriage unit and CR timing belt to the CR frame ASSY.
2) Tighten the screw (TAPTITE CUP S M3x6) firmly.
(9) Remove the Belt tension spring from the CR frame ASSY.
Fig. 3-151
Guard film
Guard film spring
“A”
CR frame ASSY
Guard film
6b
7
Carriage motor
6a
harness
TAPTITE CUP S M3x6
Belt tension spring
CR frame ASSY
To Next Page
Loading...
Need help?
General
