5-77
Confidential
AMS03 (Printing assurance 3)
- Selectors 5 and 6: Measure for black streaks at trailing edge of recording
paper
When the trailing edge of the recording paper goes through the paper feed roller,
black streaks may appear on the printed paper in the case of high-density
printing, because the paper is stretched around the paper ejection roller.
While the feed amount is corrected based on printing density, the level of stretch
differs by material of the recording paper. Therefore, black streaks at the trailing
edge of the paper should be improved by switching the feed correction value for
the paper.
AMS04 (Maintenance assurance 1)
- Selector 1: Disabling inter-machine variation calibration for paper
remaining sensor
This selector disables inter-machine variation calibration control of the paper
remaining sensors for all trays. When calibration is turned OFF, Middle to Near
sensor calibration is disabled. Consequently, when the paper amount is Near, the
sensor value is immediately reflected. (operation is equivalent to that of Regular
Ink cartridge model equipped with ink remaining sensor.)
Selector
No.
Function Setting and Specifications
1
|
4
Not used.
5
6
Measure for black streaks at
trailing edge of recording paper
No. 5 6
0 0 : Machine correction value (default)
0 1 : 1/2 of machine correction value
0 0 : 2/3 of machine correction value
1 0 : No correction
7
8
Not used.
Selector
No.
Function Setting and Specifications
1
(Simple Ink cartridge model only)
Disabling inter-machine variation
calibration for paper remaining
sensor
0: Calibration ON (default)
1: Calibration OFF
2
LED display setting in Sleep
Mode
0: Blinking (default) 1: OFF
3
Not used.
4
Automatic purging for color ink 0: Enable (default)1: Disable
5 Not used.
6 Periodic purge
0: Enable (default)1: Disable
7 Not used.
8 Automatic purging for black ink
0: Enable (default)1: Disable
To Next Page
Loading...
Need help?
General
